![]() ![]() There may be times that you want to specify a color, linetype, or layer for a particular line entity that makes up the Din Rail. ![]() This determines whether the DIN or WW table (of the default_cat.mdb) displays when you click Catalog Lookup on the Panel Layout - Component Insert/Edit dialog box. Values are either DIN or WW based on whether the spreadsheet record is a din or wire way. Name used to tie into the catalog lookup table. Added as Multi-BOM on the created Din Rail block. Added as Multi-BOM on the created Din Rail block.Īssembly code for standoff bracket. Added as Multi-BOM on the created Din Rail block.Ĭatalog number for standoff bracket. Name of AutoCAD block for standoff bracket. If Yes, the button is enabled and you can select standoff brackets. ![]() If No, then the button is disabled on the dialog. Name of AutoCAD block for the drill hole.Īllow standoff brackets, Yes or No. Length of rail to shift from one piece of rail to the next to make sure last piece is not less than the minimum length. Enter a SLOTLEN of 0.0 to generate a block without slots.ĭistance from channel line to the origin repeated for each channel line.ĭistance from origin to channel end for each channel. Description used for dialog listing only.ĭin rail width distance between the top and bottom rail lines.ĭistance between the din rail centerlines.ĭistance between the din rail centerlines used for nonsymmetrical din rails.ĭistance between bottom center line and the slot centers used for nonsymmetrical din rails.ĭistance from the origin of the din rail to the center of the slots used for off-center din rails.ĭistance from the origin of the din rail to the din rail bottom used for off-center din rails.ĭistance from the beginning of the din rail to the center of the first slot.ĭistance between slots measured from the center of each slot.
0 Comments
Leave a Reply. |